ProX XC-IEC14-25 25FT IEC Power to 110v Male Power Cord

Introducing the ProX XC-IEC14-25, a 25 ft. replacement power cord that gets your gear connected when the outlet is nowhere near the stage. Anyone who has worked a room knows the problem. The powered speaker is on a pole 20 ft. out, the only live circuit is against the back wall, and the 6 ft. cord in the box is useless. The usual fix is daisy chaining a stack of thin extension cords, which is how you end up with voltage drop, heat, and an amp that shuts down in the middle of the second set. The XC-IEC14-25 solves it in one run, with heavy 14 AWG oxygen-free copper carrying full current the entire 25 ft. without a single connection point in between. NEMA 5-15P Edison Plug The wall end terminates in a standard 3-prong NEMA 5-15P grounded plug that drops into any 120V outlet, power strip, wall box, or rack mounted power distribution unit. The third pin carries a true safety ground all the way back to the source, which matters far more on a long run than it does on a short one. IEC 60320 C13 Female Connector The gear end uses the universal IEC 60320 C13 female connector found on the back of most professional audio, video, and lighting equipment. That covers power amplifiers, powered speakers, mixing consoles, rack processors, media servers, computers and monitors, video switchers, and lighting controllers. If your gear takes a removable power cord, this is almost certainly the connector it needs. 25 Ft. Single Run The full 25 ft. length is the whole point. One cord, two connection points, no adapters and no chained extension cords stacking up resistance along the way. Fewer connections means fewer places for the circuit to fail and fewer things to trip over on a dark stage. 14 AWG Oxygen-Free Copper Conductors The 14 AWG oxygen-free copper core is what makes a 25 ft. run practical. Distance and voltage drop go hand in hand, and thin 18 AWG or 16 AWG cable starves the gear at the far end while the cord itself heats up. Heavier copper keeps resistance low across the entire length, so an amp pulling hard at 25 ft. sees the voltage it is supposed to see. 93% Braided Shield A 93% braided shield wraps the conductor bundle to help contain electrical noise. On a 25 ft. run, that cable is going to end up laying alongside mic lines, DMX runs, and audio snakes for most of its length, and shielding does real work in that situation. Flexible PVC Jacket The long lasting flexible PVC jacket stays pliable in cold rooms and coils clean at the end of the night, which counts for a lot at this length. It also resists the scuffing and crushing that comes with 25 ft. of cable running across a floor, under a ramp, and through a doorway. Tested One Cable at a Time Every XC-IEC14-25 is tested before it leaves the building. Not a sample pulled from the batch, but each cable individually, so the cord you pull out of the case at showtime works the way it did on the bench. Sold Single or by the Case The XC-IEC14-25 is available as a single cable, in a 5 piece master box, or in a 15 piece master box. Rental houses, install crews, and production companies that go through long cords can stock a full set of matched spares in one order. Each cable consists of the following:• 14 AWG (OFC) Oxygen-Free Copper Conductors • 93% Braided Shield to eliminate noise• Maximum Signal transfer and tone quality• Long Lasting Highly Flexible PVC jacket Designed by Professionals. Built for Performers. Backed by 40 Years of Excellence.